Top rope solo grigri reddit. Attach the GriGri and an extra locker to my harness.

Top rope solo grigri reddit. Or use a grigri and rap down the other strand. I climbed sporadically since 2017 and more seriously since the start of this year. I have used the grigri for self belay on top rope a bunch and it seems fine. For top rope solo I used a Micro Traxion and a Kong Duck on separate lines (yes I fixated both strands it the top from seperate bolts). edit: Also you have an ascender but not a grigri? I wouldn't ever use a grigri for TR soloing in any form unless you've modified it yourself for that purpose. Or use the atc and back up the rap with a prusik on the single rope. The setup I mentioned allows you to climb freely without having to mess with the rope. I have the normal gear for sport climbing, including a GriGri, and wanted to throw a potential TR solo setup idea out there: Set up an anchor and fix both strands of the rope. Grigri top rope solo Hey r/climbing, I'm trying to practice a route that I want to free solo (nothing crazy but long) and I'm considering buying a grigri so that I could setup a top rope and belay myself for practice. Fix the middle of your rope. The best and simplist method for top rope self belay BY FAR is to tie in on one end of the top rope and thread the other end through a grigri. Two micro traxions, shunt, gri gri (must be annoying to always tighten the rope). Rap to the bottom of the climb and probably slightly weight one end of the rope. I use Steph Davis method since it works best from all the different ways I've tried to do it. There are instructions for leading solo on a grigri online. I lurked this page a lot, today I want to share this climb. Is this really bad? What setup should I go for? I top rope solo very frequently (4-5 times a week) on hard routes that I fall on for training and I use a grigri2 as my primary device. I must say that it was a bit scary at first. I suppose the other (hopefully obvious) danger that hasn't been mentioned yet, is the rope may be rubbing against an edge depending on your set up. Whenever I read threads about top rope solo, everyone agrees on using one device to self-belay, and some kind of backup in case your belay device malfunctions. Simple locker for the main anchor (quicker and ok enough on eye-bolts), no backup anchor but a rebelay with a clove hitch on the How to use: To load the GriGri for a solo it is extremely important that you load the rope using the climber logo connected to the anchor at the top and the hand logo is the free slack . I have been looking into rope soloing on lead with a grigri 2, and have heard some horror stories about carabiners breaking and the device failing to lock. I'm really starting to believe that there are loads of people on the internet who bash the grigri for this setup without having used it themselves by or at least enough to tinker with it to get it working well. A grigri can fail if oriented upside down. Google it to find pictures of how to orient the devices. 2 mm, Micro Traxion for the cache loop. But if you're doing normal top rope climbing, your belayer has a belay device, and that's it, no backup. Backup can be a second rope, knots, a second device, etc. After some consideration I went for a grigri with chest harness (to keep it oriented right) as a main device and a Petzl ASAP as backup for the lead solos. Solid anchor on two trees, simple climb, thus allowing me to just drag in the slack along the way, in essence reversing the rapell down. If you use a grigri you have to stop climbing to pull rope through, this isn't necessary with 2 traxions. System: Unmodded Grigri 2019, Petzl Volta 9. Most likely I won't buy a (semi-)static rope, so I will just use my dynamic one. Find rock climbing routes, photos, and guides for every state, along with experiences and advice from fellow climbers. I am thinking about starting to top rope soloing on one of my projects, and I see so many opinions on the best way to do this. I just had my first solo top rope send, using a basic rapell setup with a normal brake and prusik, on my dynamic rope. TR solo on one strand and tie knots, rap down double rope and untie your knots. Attach the GriGri and an extra locker to my harness. Gri gri or gri gri + will work but will require you to manually pull rope through every once in a while. Rope rope solo advice! (First time) Hi climbers, I’m planning on top rope soloing a 50m single pitch, anchor at the top, throw my 70m rope down, rap, and then climb back up. Some people remove the little tab on the grigri and grind / sand it smooth so the grigri will orient correctly in a fall. Are there any ways around this, besides for the obvious solution of backup knots, like attaching the grigri to your belay loop with a sling, or some other way of using it? I just had my first solo top rope send, using a basic rapell setup with a normal brake and prusik, on my dynamic rope. Saftey considerations: The lever of a gri gri is on the left side of the device therefore the grigri must be on the left side of your tie-in figure 8 knot. . Am I going to die? To avoid manually feeding slack through the Gri-Gri, I personally use a Trango Vergo in its place (in a single strand setup, above a MicroTrax), it feeds automatically while climbing when the rope is weighted. You are over complicating this. Check out the wren soloist. Grigri upside down for better feeding. If I tie myself in and tie backup knots would this be a safe enough setup? The best current setup for top rope soloing is a combo of the Trango Vergo and the Microtrax. Going to use a standard grigri on my belay loop and a Petzl shunt as a backup on my leg loop (but also pas’d up to my main harness loops). A single rope can be cut with relative ease in this situation compared to normal use. qxks tvqpghu dkfmu zmaxf rucr ypy owdbu rwjo lploy uzu